Hi,
I have access to another Zynq-Evalboard-Schematic, I will check the reset connection on Monday, but if i remember correctly the JTAG has connection to a reset.
I am using the SDK for the Zynq. And I already had problems unbricking Zynq on a testboard, where the reset was not connected.
Maybe there are other ways to reset the Zynq, but I just haven't seen them.
So I would just feel safer, If I could connect a Xilinx Plattform Cable to the board, reset the Zynq and have full access to it.
on the other hand, it is no ones job here, to let me feel safer...
br
ESI