Parallella Community

Hi

I have installed and configured SLURM https://computing.llnl.gov/linux/slurm/
as a resource manager for my 4 parallella boards with my desktop as the controller node.
And so far it looks ok (havent done much testing yet).
However, since I do not have any previous experience with SLURM and it required quite a bit of fiddling
around to make it work, I was hoping that someone else with experience could help me validate the setup
that I have created....

If there is interest, I can post a short (and ugly) write-up of the steps I followed.

Cheers

S<

http://censix.com

Cencix,
That's great! I know someone else was working on slurm for an 8 board cluster, I will check on the status.
I am sure it would be helpful to get the discussion started if you would post the steps you went through.
Andreas

Would be great to get a how-to for this up on the wiki!

Cheers,

Andrew

Andreas & Andrew

I will post what I have over the coming days. I would say that it isn't "how-to wiki material" yet until someone else replicates it. Lets see.

Soren

Well, I knew I would eventually get scooped on the SLURM thing if I sat around too much, but hey, this is great!

I will try can get back on top of my parallella project after I go on vacation next week and see if I can also get SLURM working in some fashion.