Parallella Community

Posted: **Mon Mar 03, 2014 9:17 pm**

Flashed the Parallella16_z7020wGPIO_131220.zip IMG onto my SD card. Plugged it in. Turned on the power then nothing. Can't see an IP address to connect too, and all I get on the monitor is a message saying Not Optimum Mode.

Can someone point me at an SD Card image that works? Currently all I have is an expensive ornament.

Posted: **Tue Mar 04, 2014 8:10 am**

This thread may help you:
viewtopic.php?f=48&t=844

Posted: **Tue Mar 04, 2014 10:16 am**

Thanks - I'll have a look.

David

Posted: **Fri Mar 07, 2014 10:34 pm**

Apologies for all the confusion with the SD card image!!!

Please follow the SD card creation recipe below:

http://www.parallella.org/create-sdcard

Cheers,
Andreas

Posted: **Sat Mar 08, 2014 6:06 am**

Posted: **Tue May 06, 2014 10:13 pm**

The issue for me is getting the SD card partitioned first. the "flexible" instructions (http://www.parallella.org/create-sdcard/) say to create a
128MB FAT32 + Remainder (>6GB) EXT4.
I have not found a windoze program to do that yet
MiniTool Partition Wizard does not all anything larger than 64KB for a FAT32.
SDFormat, SDMinste, don't recognize the type of SD card.

Yes I plan to setup a dual boot on the laptop for Ubuntu but was hoping to validate the 2 parallella boards first.

Anyone been able to partition with windoze per the "flexible" instructions?

Regards,
MJ

Parallella Community

Where is an SD Card image that works?

Where is an SD Card image that works?

Re: Where is an SD Card image that works?

Re: Where is an SD Card image that works?

Re: Where is an SD Card image that works?

Re: Where is an SD Card image that works?

Re: Where is an SD Card image that works?