Hi, I've successfully built the elink FPGA project in Vivado 15.3
I want to test this and will also want to test further FPGA development.
I won't want to keep rebooting to do this but will want to load the FPGA config from the Linux command prompt.
Are there any issues doing this?
I'm guessing I'd need to do something link
rmmod elink-module
cat image >/dev/xdevcfg
modprobe elink-module
Is there an e-link module? lsmod shows nothing so maybe the driver is built into the kernel.
If so what's the effect of loading a new image into the FPGA whilst Linux is running?
Thanks