I have a parallella board with HDMI, I boot the board with pre-built image successfully.
I build the linux image in both native-platform(arm) and cross-platform(amd64),
I use serial console to watch the boot procedure, after u-boot load the image, the console is frozen,
and no output from HDMI.
following image compiled in native-platform
## Booting kernel from Legacy Image at 03000000 ...
Image Name: Linux-3.14.12-parallella
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 4910072 Bytes = 4.7 MiB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
## Flattened Device Tree blob at 02a00000
Booting using the fdt blob at 0x02a00000
Loading Kernel Image ... OK
OK
Loading Device Tree to 1fffa000, end 1ffff19e ... OK
and this is compiled in cross-platform
## Booting kernel from Legacy Image at 03000000 ...
Image Name: Linux-3.14.12-parallella-xilinx-
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3350744 Bytes = 3.2 MiB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
## Flattened Device Tree blob at 02a00000
Booting using the fdt blob at 0x02a00000
Loading Kernel Image ... OK
OK
Loading Device Tree to 1fffa000, end 1ffff19e ... OK
I use the default config, but the image size is very different, 3.2MB vs 4.7MB, why?
and which repo can work with HDMI?